Nous vous offrons une qualité et une sécurité de premier ordre, associées à un service d'envergure mondiale et
à une assistance maximale pour résoudre vos problèmes de surveillance.
To satisfy new standards including IEC 62955 and IEC 60364-7-722, the charging of electrical vehicles requires residual current sensors to avoid hazardous situations in cases where the vehicle battery (DC) is connected to the home power supply (AC). Generally, AC/DC sensitive residual current sensors can be used where direct current and alternating current circuits are directly connected and therefore AC/DC leakage currents can occur.
Typically type A residual current circuit breakers (RCCBs) are installed in private households. However, these RCCBs are to identify and deactivate DC fault currents. In order to charge an electric vehicle (EV) from a home power supply, a costly type B RCCB would be required to guarantee safety in the event of a DC fault current. By using the benvac DI sensor in an IC-CPD or a wall box, the requirements for electrical safety and all-current fault detection can be fulfilled by the patented measuring method and this at a significantly reduced cost than comparable type B RCCB.
A single DI sensor simultaneously monitors all currents in phases and neutral conductors sensing AC/DC fault currents. The sensors can activate automatic shut-off in the event of hazardous electrical faults. As the residual currents to be monitored only occur in the event of electrical faults and are extremely low (mA), maximum measurement precision is critical. In addition, a fast response time is required to maintain safety features.
Charging mode 2
Charging mode 3
|Notices||RDC121||414.3 Ko||EN||20.10.2021 12:52:08|
|Version||Type VAC||Type Bender||Art. No.|
|6 mA DC||T60404-N4641-X904||RDC121-4||B94042493|