v5.32
operator
manufacturer
Last updated on
Understanding LED Indications
tip
Looking for the meaning of the HMI/RFID LEDs? Check out the RFID/LED boards page.
1. Introduction
When you power on or reset a Bender Charge Controller, its front-facing Status LED(s) will indicate the current system state. Learning to read these indicators allows you to:
- confirm whether the device is booting or ready,
- diagnose issues early, and
- determine when you can safely access the Config UI.
This page summarizes LED patterns across three controller types (CC613, CC612, ICC1324) and distinguishes regular vs. Eichrecht firmware behavior.
- CC613
- CC612
- ICC1324
- Regular
- Eichrecht
- Ethernet indications
The status LED is located on the front of the controller.
- Regular
- Eichrecht
- Ethernet indications
The CC612 has three LEDs (Alarm, Ready, PLC) that are to be found on the controller.
The CC612 does not have an integrated Ethernet Port. The Ethernet activity is indicated by the USB adapter.
- Regular
- Ethernet Indications